← Kyron SsangYong Kyron repair manuals →
Autopapyrus · SsangYong Kyron 2.0 XDi (2010)
https://autopapyrus.com/guides/ssangyong/kyron/wiper-blade-replacement/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.

SsangYong Kyron 2.0 XDi (2010): Wiper Blade Replacement

The 2010 SsangYong Kyron uses classic hook-type (J-hook) wiper blade attachments. The replacement is done by hand without tools in a few minutes. It is recommended to replace the blades every 6-12 months, or whenever streaks appear on the glass.

Difficulty: Easy Time: 5-10 minutes Steps: 9 Tools: None required

Parts

2
№PartGenuine part no.Alternatives
01 Driver-side wiper blade 550 mm (22") Bosch AeroTwin AR22U, Denso DUR-055L
02 Passenger-side wiper blade 500 mm (20") 7832509001 Bosch AeroTwin AR20U, Denso DUR-050L

Part numbers are from the manufacturer's original catalogue. Check them against your VIN before ordering.

There's a full repair manual for this car Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online). See manuals →

Step by step

9 steps
  1. Lift the wiper arm away from the windshield to the upright position until it locks. Start on the driver's side.
  2. Turn the blade perpendicular to the arm to get access to the plastic retaining clip.
  3. Press the plastic release tab on the side of the blade and at the same time pull the blade down along the arm. It will come off the hook.
  4. Remove the old blade completely, holding the arm with your hand. Do not let the metal arm snap back against the glass.
  5. Take the new blade and insert the arm's hook into the blade's mounting slot until the lock clicks.
  6. Check that the blade is secure. Give it a light tug to try to pull it off the arm. It should not come off.
  7. Lower the arm back onto the glass with a smooth motion.
  8. Repeat steps 1-7 for the passenger-side blade.
  9. Turn the wipers on at low speed and check for skipping, squeaking or chattering.

Common mistakes and warnings

  • Do not leave a metal arm without a blade standing in the upright position
  • If it falls, it can crack the windshield
  • Always hold the arm with your hand when removing and installing the blades
  • If the new blades leave streaks, wipe the rubber edges with a clean cloth and isopropyl alcohol, and degrease the glass