Autopapyrus · Renault Talisman 1.5 dCi (2019)
https://autopapyrus.com/guides/renault/talisman/wiper-blade-replacement/
https://autopapyrus.com/guides/renault/talisman/wiper-blade-replacement/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Renault Talisman 1.5 dCi (2019): Wiper Blade Replacement
On the first-generation Talisman, the wiper blades can be replaced without tools. The procedure is completely safe and takes only a few minutes. It is recommended to replace the blades every year or whenever visibility gets worse.
Parts
2| № | Part | Alternatives |
|---|---|---|
| 01 | Wiper blade Renault (front driver side, 650 mm) | Bosch Aerotwin A650S, Valeo Silencio |
| 02 | Wiper blade Renault (front passenger side, 400 mm) | Bosch Aerotwin A400S, Valeo Silencio |
There's a full repair manual for this car
Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online).
See manuals →
Step by step
6 steps- Open the hood and park the car so that you can easily reach the wiper arms.
- Lift both wiper arms up so that they stand perpendicular to the windshield.
- For the front left (driver side): - Press the plastic locking tab (clip) on the inner side of the arm, where the blade connects to the adapter. - Slide the old blade down and pull it out of the adapter slot. - Insert the new blade into the adapter until the locking tab clicks.
- For the front right (passenger side), repeat the same procedure. This arm is shorter (400 mm versus 650 mm).
- Lower both arms back into place. They should settle quietly and lie parallel to the windshield.
- Check how the wipers work. Run them a few times and make sure the blades press evenly against the glass.
Common mistakes and warnings
- Do not mix up the sizes of the left and right blades (650 and 400 mm respectively)
- During installation, make sure the blade is fully locked into the adapter, because an incorrectly installed blade can come off while driving
- If the arms are in the "park" position, lift them slightly before starting work to avoid damage