Autopapyrus · Volkswagen Amarok (1st generation)
https://autopapyrus.com/guides/volkswagen/amarok/cabin-air-filter-replacement/
https://autopapyrus.com/guides/volkswagen/amarok/cabin-air-filter-replacement/
Compiled automatically from service literature and owner experience. Specs are for the typical configuration — check them against your exact car before you start.
Volkswagen Amarok (1st generation): Cabin Air Filter Replacement
The cabin air filter on the Volkswagen Amarok is located on the front passenger side, under the glove box. Replace it every 15,000-20,000 km or once a year. The procedure requires no special skills and takes about 15 minutes.
Part
| № | Part | Genuine part no. | Alternatives |
|---|---|---|---|
| 01 | Cabin air filter | 7E0819631 | Mann, Filtron, Bosch |
| 7H0819631 | |||
| 7H0819631A |
Part numbers are from the manufacturer's original catalogue. Check them against your VIN before ordering.
Tools
3- 5.5 mm socket
- Torx T20
- ratchet
There's a full repair manual for this car
Every system, wiring diagrams and torque specs — not just this job. Haynes AutoFix (online).
See manuals →
Step by step
9 steps- Slide the front passenger seat all the way back for easier access.
- Remove the screws holding the lower side sill trim (passenger side) using a Torx T20 driver. Remove the trim.
- Remove the fasteners of the cabin air filter housing cover using a 5.5 mm socket (usually 2 screws).
- Remove the cover by pulling it toward you.
- Pull the old filter out of the housing. Wipe the housing with a dry cloth to remove dust and leaves.
- Install the new filter, observing the airflow direction (the arrows on the filter frame must point toward the cabin).
- Put the cover back in place and tighten the screws with the 5.5 mm socket.
- Reinstall the sill trim and tighten the Torx T20 screws.
- Return the front passenger seat to its original position.
Common mistakes and warnings
- Do not try to clean and reuse the old filter
- This results in poor air filtration and fogged windows
- Do not use excessive force when installing the cover, as you can damage the plastic clips